In the long-term operation of the rotary furnace, wear and tear between components is essential. Wear and tear can affect the operational efficiency of the kiln, and if not repaired or replaced in a timely manner, it can bring more problems. In order to reduce the maintenance and replacement costs caused by wear and tear, it is important to master methods to reduce wear and tear.
1. Lubrication of the driving device
The lubrication of this part of the rotary furnace is mainly between gears.
, Due to the very limited pores between gears, it is not reasonable to use graphite as a lubricant. Instead, oil injection lubrication should be used. To avoid vertical lubrication, it should be noted that this lubrication method requires timely inspection and confirmation of the oil injection status by the staff2. Lubrication between the cylinder base plate and the rolling ring
The fluidity and smoothness of graphite are very good, suitable for lubrication in areas that require a large amount of lubricant.
3. Lubrication of the support device
The lubrication of the rolling ring and towing wheel surface of the rotary furnace is relatively simple. However, it should be noted that the size of the graphite block may change during long-term operation of the equipment. If the graphite block is found to be smaller, the maintenance personnel of the vertical kiln must replace it in a timely manner, otherwise the desired lubrication effect will not be achieved
Doing a good job in lubrication between various systems and devices of the rotary furnace can better ensure the stability of equipment operation and reduce wear issues
